Ord 2015-020/Height Warrant - Laserfiche WebLink

Home Browse Search

ARTICLE 5. LOT AND BUILDING REGULATIONS San Marcos, Texas ARTICLE 5. LOT AND BUILDING REGULATIONS 5.1. INSTRUCTIONS 5.1.1. LOT AND BUILDING REGULATIONS 5.1.2. INSTRUCTIONS 5.1.3. Lots and buildings located within a Regulating Plan governed by this Code, and previously approved by City Council, shall be subject to the requirements of this Article. 5.1.4. Such plans require administrative approval by the DRC. 5.1.5. Building and site plans submitted under this Article shall show the following, in compliance with the standards described in this Article: a. For preliminary site and building approval: i. Building Disposition ii. Building Configuration iii. Building Function iv. Number of dwelling units V. Base Residential Density vi. Building square footage vii. Parking Location Standards viii. Lot Lines b. For final approval, in addition to the above: i. Landscape Standards ii. Signage Standards iii. Special Requirements, if any 5.1.6. Special Districts that do not have provisions within this Code shall be governed by the standards of the LDC pre- existing zoning. PRE - EXISTING CONDITIONS 5.1.7. Existing buildings and appurtenances that do not conform to the provisions of this Code may continue in use as they are until a Substantial Modification is requested, at which time the provisions of this section shall apply. 5.1.8. The modification of existing buildings is permitted By Right if such changes result in greater conformance with the specifications of this Code. 5.1.9. Where buildings exist on adjacent Lots, the DRC may require that a proposed building match one or the other of the adjacent Setbacks and heights rather than the provisions of this Code. 5.1.10. The restoration or rehabilitation of an existing building shall not require the provision of (a) parking in addition to that existing nor (b) on -site stormwater retention /detention in addition to that existing. Existing parking requirements that exceed those for this Code may be reduced as provided by Table 5.5 and Table 5.6. SC40 SMS024 OVERSION 10