Laserfiche WebLink
ARTICLE 3. RESIDENTIAL CODE FOR ONE AND TWO- FAMILY DWELLINGS <br />Section. 14.041. Amendments. <br />The International Residential Code for One and Two - Family Dwellings, adopted in section <br />Section 14.002, is amended as follows: <br />Section R103 is deleted. <br />Section R104.7 is deleted. <br />Section R109.1.1 is amended to read as follows: <br />R109.1.1 Foundation inspection. Form surveys shall be performed prior to Placement of <br />plumbing piping and the report shall be on site at the time of foundation inspection. Inspection <br />of the foundation shall be made after poles or piers are set or trenches or basement areas are <br />excavated and any required forms erected and any required reinforcing steel is in place and prior <br />to the placing of concrete. The foundation inspection shall include excavations for thickened <br />slabs intended for the support of bearing walls, partitions, structural supports, or equipment and <br />special requirements for wood foundations. In Flood Plain areas additional requirements exist in <br />Section R109.1.3. <br />Section RI 12 is amended to read as follows: <br />R112 Board of Appeals. Means of Appeal. The Construction Board of Appeals is designated to <br />hear all appeals regarding this code following procedures and process identified in the <br />International Building Code and its amendments. <br />Section R 313.2 is deleted <br />Sections R905.7 and R905.8 are deleted and replaced with the following: <br />R905.7. Wood shingles and shakes are prohibited as new or replacement roofing material except <br />that wood shingles and shakes as the primary roofing surface in existence on January 1, 2001, <br />may be replaced with UL listed fire retardant shingles or shakes that are approved by the fire <br />marshal. <br />Section R905.10 is amended by adding the following: <br />R905.10.1.1. Any metal roof covering, gauge 26 or smaller gauge, shall be installed over a solid <br />deck sheathing 26 gauge metal roofing may be installed where on 2x4 lathing is provided or it <br />is installed per manufacturers specifications <br />