Res 2004-214 - Laserfiche WebLink

Home Browse Search

RFP 24-057 587 -0702 I quantities measured, to establish normal operating values of the systems. Follow the procedures and format specified below: 1. Draft reports: Upon completion of testing, adjusting, and balancing procedures, prepare draft reports on the approved forms. Draft reports may be hand written, but must be complete, factual, accurate, and legible. Organize and format draft reports in the same manner specified for the final reports. Submit 2 complete sets of draft reports. Only 1 complete set of draft reports will be returned. 2. Final Report: Upon verification and approval of draft reports, prepare final reports, type written, and organized and formatted as specified below. Submit 2 complete sets of final reports. 3. Report Format: Report forms will be those standard forms prepared by the referenced standard for each respective item and system to be tested, adjusted, and balanced. Bind report forms complete with schematic systems diagrams and other data in reinforced, vinyl, three-ring binders. Provide binding edge labels with the project identification and a title descriptive of the contents. Divide the contents of the binder into the below listed divisions, separated by divider tabs: a. General Information and Summary b. Foul Air Treatment System I G. Report Contents: Provide the following minimum information, forms and data: 1. General Information and Summary: Inside cover sheet to identify testing, adjusting, and balancing agency, PROPONENT, CITY, or CITY's representative, and Project. Include addresses, and contact names and telephone numbers. Also include a certification sheet containing the seal and name address, telephone number, and signature of the Certified Test and Balance Engineer retained by the PROPONENT. Include in this division a listing of the instrumentations used for the procedures along with the proof of calibration. 2. The remainder of the report will contain the appropriate forms containing as a minimum, the information indicated on the standard report forms prepared by NEBB, for each respective item and system. Prepare a schematic diagram for each item of equipment and system to accompany each respective report form. As a minimum record, all blower speeds, damper settings, flows, and pressures required for balancing. H. Calibration Reports: Submit proof that all required instrumentation has been calibrated to tolerances specified in the referenced standards, within a period of six months prior to starting the testing. 1.05 QUALITY ASSURANCE I A. Agency Qualifications: 1. PROPONENT shall employ the services of an independent testing, adjusting, and balancing agency meeting the qualifications specified below, to be the single source of responsibility to test, adjust, and balance the 15950-3