Laserfiche WebLink
SUBDIVISIONS <br /> . 3m <br /> a � <br /> 2. Loop Lane.A loop lane is a two-way street, no portion DIVISION 3: LOTS <br /> of which may be more than two hundred and fifty(250') <br /> feet in length. The interior landscaped area must have an Section 3.6.3.1 Lot Standards <br /> average width of at least seventy five (75)feet. A. Lot Frontage. Every lot shall have frontage on a public street <br /> FIGURE 3.9 LOOP LANE except as allowed under the courtyard or cottage court building <br /> types in Section 4.4.6.9 or Section 4.4.6.4. <br /> I B. Lot Arrangement. <br /> 1. Lots shall be subdivided to permit conformance with all <br /> laws and ordinances and to ensure orderly urban growth, <br /> proper building arrangement and to provide city services <br /> and facilities. <br /> 2. Lot dimensions shall provide for the potential development <br /> of all lots and future compliance with the development <br /> - � standards of this Development Code. <br /> 3. Irregularly-Shaped Lots. Irregularly-shaped lots shall <br /> have sufficient width at the front setback line to meet lot <br /> Section 3.6.2.3Perimeter Road Requirement and width requirements in Chapter 4. <br /> Participation <br /> a. Triangular,tapered, or flag lots shall be not be <br /> A. Improvement of Adjacent(Perimeter) Roads and Utilities. permitted except for use as dedicated parkland lots. <br /> When an area within a proposed subdivision or development <br /> plat,whether residential or non-residential, abuts on one or b. Severely elongated (in excess of a three to one(3:1) <br /> both sides of an existing substandard road or utility facility, length to width ratio) lots shall not be permitted <br /> or a planned or future road or utility facility as shown on the except for use as dedicated parkland lots, or for use <br /> City's Thoroughfare Plan and/or adopted plans related to water as townhome or zero lot line building type lots. <br /> and wastewater,the subdivider/developer shall be required c. Townhome and zero lot line lots may not exceed a six <br /> to improve its fair share of the road (including appurtenant to one (6:1)length to width ratio. <br /> curbs,sidewalks,barrier-free ramps, storm drainage facilities, <br /> screening and landscaping, median openings, left turn lanes, d. Exceptions to the irregularly shaped lot requirements <br /> and water quality or erosion controls) and utility facilities,to fall under the alternative compliance process in " <br /> provide or bring the facilities to city standards,or to replace accordance with Section 2.8.4.1. <br /> them with standard city road or utility facilities as determined <br /> by a traffic or other public facilities impact study, if required,at (Ord. No.2019-45, 12-17-19) <br /> no cost to the City. C. Lot Dimensions <br /> B. Calculation of Fair Share.The developer's share of 1. Lots that are occupied or are intended to be occupied shall <br /> improvements to a substandard perimeter road is the equivalent conform with the minimum lot size, lot width and lot depth <br /> of one-half of the street up to a maximum twenty four(24)feet requirements provided under Chapter 4. <br /> of pavement(not including curb). <br /> 2. Exceptions to the minimum lot size, lot width and lot depth <br /> requirements fall under the alternative compliance process <br /> in accordance with Section 2.8.4.1. <br /> 3:30 San Marcos Development Code Amended:September 1, 2020 <br />