06251957 Regular Meeting - Laserfiche WebLink

Home Browse Search

t I , 10. No streets names shall be used which will duplicate or be confused with the names of existing streets Street names shall be subject to approval of the City CounciL 11. Alleys shall be minimum width of fifteen (15) feet and shall be provided in commercial and industrial districts and in residential districts whenever adequate land is available for the platting of an alley. 12. Dead-end alleys shall be avoided where possible, but if unavoidable, shall be provided with adequate turn-around facilities at the dead-end as determined by the City Council. 13. When alleys are provided in the subdivision, all utilities shall be installed in said alleys if the topography is favorable. 14. Where alleys are not provided, easements of not less than seven and one-half (7t) feet in width, or wider!f necessary, shall be provided on each side of the rear lot lines and side lines for utilities. All utilities shall be installed in said easements or alleys 0 SECTION C. Blocks and Lots The blocks and lots of subdivisions shall conform substantially with the following design standards I 1. the desirable maximum block length is twelve hundred (1200) feet and the desirable minimum length is six hundred (600) feet. 2. Residential lots shall not be less than fifty (50) feet in width and not less that five thousand seven hundred fifty (5750) square feet in area and residential corner lots shall be sixty (60) feet in width and not less than six thousand nine hundred (6900) square feet in area; provided that residential lots not served by public sewerage system and located in a subdivision which will not be served immediately by a central disposal unit shall be not less than sixty (60) feet wide and not less than nine thousand (9000) square feet in area. 110