Ord 2000-022 - Laserfiche WebLink

Home Browse Search

(5) A completed development plat as described in subsection (c), including a geologic assessment and a technical report as described in subsections (d) and (e). (c) A completed development plat must be submitted on 24" by 36" sheets, and must include the following: (1) Site boundaries including all bearings and distances, with any relevant recharge zone boundaries clearly labeled. (2) Topography and drainage plan of the entire site at two foot contour intervals. (3) The centerline of all rivers, creeks, streams or drainage areas that drain an area greater than 50 acres. (4) The location of all floodways and 100-year floodplain as shown on flood insurance rate maps or as calculated using acceptable engineering standards. (5) The location of all sensitive features on the site as identified in the geologic assessment. (6) The location and dimensions of all critical water quality zones and water quality transition zones, if applicable. (7) A survey of all trees 10 caliper inches in diameter and greater, as measured four feet above the ground. On sites greater than ten acres, a digital aerial photograph may be superimposed on the development plat in lieu of an on-the-ground tree survey. (8) The location and dimensions of all existing improvements on the property including all existing impervious cover such as driveways, parking areas, buildings and similar structures. (9) All proposed improvements on the 'property including all proposed impervious cover such as driveways, parking areas, buildings and similar structures. (10) The drainage patterns and approximate slopes anticipated after major grading activities, as determined by a Texas licensed professional engineer. (11) Identification of all areas where soils will be disturbed, and all areas where soils will not be disturbed. (12) A table of summary information that includes the following: (A) The total acreage ofthe site. (B) The area and percentage of existing impervious cover, by type. (C) The area and percentage of proposed impervious cover, by type. (D) The total area and percentage of impervious cQver by type. (13) The location and type of all proposed temporary BMPs. (14) The location, dimensions and calculations of total suspended solids removal rate for all proposed permanent BMPs, as determined by a Texas licensed professional engineer or a hydrologist. (15) All standard notes that may be required by the city for compliance with applicable regulations. (16) Name and address of the owner of the property. (17) Name and address of the architect, engineer or surveyor who prepared the plat. 8